Home

- Type U51 Sub-distribution Board

 - 400V AC 50/60 Hz

- 834 x 310 x 120 mm

External Relay for IQ7 In Enphase installations three-phase, the Q Relay (Network System Relay Controller) acts as a physical disconnect relay controller for installations.

Card for Kostal product extension. Specific card for Germany.

Electrical box (alternative current) for photovoltaic protection. Cabinet includes the wiring diagram. Required for each photovoltaic system.

AC box 230 V AC single-phase up to 6 kW with differential circuit breaker 32 A - 30 mA + surge arrester type A.

Certification in progress, installation not possible at the moment

Microinverter
Single phase
Best perfomance
25 years warranty
Online connection

- CA14V small distribution cabinet

- Indoor use, Protection II, IP44

- 400V AC 50/60 Hz, 125 A

- Dimensions: 650x300x160 mm

Install a meter in your electrical panel to use ALMA SOLAR's AI. Thanks to our AI, you'll be able to determine the consumption of each appliance each day. Our AI suggests automated actions to optimize your grid consumption.

ALMA SOLAR's AI determines the consumption of each appliance and breaks it down by category (refrigerator, hot water, heating, air conditioners, large appliances, television, standby appliances, etc.).

The 3EM-PRO meter and its clamps are connected directly to your panel. Clamp #3 is dedicated to measuring the inverter's production (regardless of brand), and clamp #2 measures the electricity coming from the grid for your power supply. Clamp #1 can be used to measure the power coming from the batteries or your electric charger (at your convenience). Using this data, our AI can advise you on the best use of your energy.

• Control your consumables remotely via the ALMA SOLAR application
• Measurement of consumption and graphic reading on the application
• Monitoring 120A consumption per phase (three-phase)
• Scenario activation based on the states of connected devices, solar production, solar battery status, weather, time, location, brightness* (*depends on a device with sensor)
• Supplied with 3 current clamps

Buy your APS EZ1 micro inverter directly from our online store. The great special feature of this APS micro inverter is that it can connect 2 solar modules. They optimize the production of the two solar modules and yet make them completely independent of each other. Thanks to this new technology, you can reduce the number of micro-inverters and optimize profitability: more power and lower costs. With the EZ1 model, monitoring is already integrated and the inverter can be controlled via Wifi or Bluetooth.
A maximum of 2 units can be connected in series.

- Type CA15V small distribution board

- Powder-coated sheet steel, 800 x 300 x 160 mm

- 400V AC 50/60 Hz, 125 A

- IP44 protection, Protection Class II

Connects in parallel to your electrical circuit and connects directly to your Solax solar inverter to monitor your home consumption and regulate the power of your solar panels.

Measures between 5A and 200A per phase for 24mm diameter cables. 

This electric cable with a section of 4 mm2 for three-phase networks over a length of 30m. You must connect to the output of your inverter to your electrical panel. It can be installed in the air, underground, in water, in concrete, indoors, in cable ducts, etc.

VDE and IEC certified cable.