Home

Set of 2 reusable handles for easy handling of the IQ-5P battery.

This single-phase Solax box allows the AC GRID output and the EPS output to be connected to the same injection point. This box works with Solax Hybrid SK-SU and Solax Hybrid X1-D-E inverters. The Solax Hybrid AC GRID output works with the power grid. The EPS output operates in the absence of electrical network, i.e. during a blackout. You have 2 inputs for 2 Solax outputs and 1 output for a parallel connection to your house grid.

Add this box if you wish to secure your power supply at all times and even in the event of a power outage.

Extend your ABB inverter warranty TRIO-5.8-TL to 10 years.

The WALLBOX power boost measures the power taken from the network, sends the data to the WALLBOX charger so that it regulates the charging power and avoids excessive energy consumption in the home, eliminating any risk of blackout.

Output raised to 97,1%
Low price
WIFI connection (included)
Lightweight
Quick start
Single-phased inverter

Output raised to 97,1%
Low price
WIFI connection (included)
Lightweight
Quick start
Single-phased inverter

- Product type: DF17U1B meter panel

- Dimensions: 1050 x 250 x 160 mm

- Power system: TN-S, 5-pole

- Rated current: In 40 A

- CA24V small distribution board

- 400V AC, 125A

- Dimensions: 650 x 550 x 160mm

If you have a FRONUIS GALVO SYMO or PRIMO Light version, you can add this card to establish a WIFI connexion.

- Model: DF27U11B meter panel

- Dimensions: 1050 x 500 x 160 mm

- Protection Class: IP2XC

- Manufactured: Germany

Low price
WIFI connection (included)
Lightweight
Quick start
Single-phased inverter

Low price
WIFI connection (included)
Lightweight
Quick start
Single-phased inverter

Output raised to 97,1%
Low price
WIFI connection (included)
Lightweight
Quick start
Single-phased inverter

Buy your communication GATEWAY TIGO ENERGY with CLOUD CONNECT an power supply box at the lowest price online only. This solution enables the communication between smart solar panels and panels with solar optimizers by TIGO TS4. The GATEWAY antenna is set up directly behind the smart solar panels, collects all the data and sends it over via RS485 cables to the CLOUD CONNECT. Thanks to this technology, all your solar panels are completely independent and you can optimize your solar installation’s power output.

Electrical box (continuous current) for photovoltaic protection. Cabinet includes wiring diagram. Required for each photovoltaic system. This DC box is needed for inverters with 2 independant entrances (2x MPPT).

DC box 2 x MPPT - DC breaker 25 A - 1000V, surge protector type 2, 1 string / MPPT - connexion with MC4.

The ECU communication gateway is the core of your network. Owners can easily monitor the status of their system using the LCD screen or get information by solar panel via the monitoring software and APS testing.

In addition to controlling the surplus management, you can remotely activate your hot water tank.

Connects directly via RS485 to the LG inverter. You will be able to monitor your home consumption and regulate the power of your solar panels. Measures up to 60A in three-phase.

- Item number: 446007

- Flush mounting, indoor use

- Multiple cable entry options

- Protection class IP31

- Wall-mounted, indoor enclosure

- Protection class II, IP54

- Rated current In 250 A

- Dimensions: 1100 x 800 x 215 mm

Measure the current of your home with this sensor that plugs around the corresponding power cable.

Electrical box (alternative current 3-phase) for photovoltaic protection. Cabinet includes the wiring diagram. Required for each photovoltaic system.

AC box 400 V AC 3-phase AC up to 10 kW with differential circuit breaker 16 A - 30 mA + surge arrester type A.

This meter measures the power injected into electrical grid, consumption of your home. The connexion type is available in the installation instructions at the bottom of this page. 

It measures a voltage from 100V to 380V. Use it for three-phase networks. Thanks to the CT clamps, there is no limit to the power measured.

Delivered with CT clamps.

This meter measures the power injected into electrical grid, consumption of your home and power from another inverter SOLAX brand or other(dual version). The connexion type is available in the installation instructions at the bottom of this page. 

It measures a voltage from 40V to 400V. Use it for three-phase networks. Thanks to the CT clamps, there is no limit to the power measured.

Delivered with CT clamps.

Immediately cost-effective
Low price
Wifi monitoring

• Easy and Fast Assembly
• Reliability and Robustness
• High-Performance Monocrystalline Cell
• 30 Years Product Warranty
• Guaranteed Performance
• 100% Made in Europe

- Model: CA25V

- Dimensions: 800 x 550 x 160 mm

- Voltage: 400V AC

- Protection: IP44

Fronius three-phase smart meter 65A-3 monitors the consumption of your home and adjusts the inverter's production. This meter communicates with your Fronius inverter and avoids the injection of surplus from your inverter into the power grid.

Through-current meter, no CT clamp required.

Electrical box (alternative current) for photovoltaic protection. Cabinet includes the wiring diagram. Required for each photovoltaic system.

AC box 230 V AC single-phase up to 10 kW with differential circuit breaker 50A - 30 mA + surge arrester type A.

Output raised to 97,1%
Low price
WIFI connection (included)
Lightweight
Quick start
Single-phased inverter

Electrical box (alternative current, triphase) for photovoltaic protection. Cabinet includes the wiring diagram. Required for each photovoltaic system.

AC box 400 V AC 3-phase AC up to 20 kW with differential circuit breaker 32 A - 300 mA + surge arrester type A.

- U52 partially assembled

- Protection class II, IP31

- Rated voltage Ue 400V AC

- Dimensions: 834 x 560 x 120 mm

Buy your APS QT2 three-phase microinverter directly from our online store. The great feature of this APS microinverter is that it allows you to connect 4 solar panels to 2 independent inputs. It optimizes solar panels production and become them completely independent from each orders. With this new technology, you reduce the number of micro-inverter and moreover you optimize profitability: More performance and less expensive.

You must order the APS cable to connect the micro-inverters to each other.

Tool to connect the MULTI-CONTACT solar cable connectors.

Compatible with Sungrow inverters
Online supervision
Integrated electrical car charge management
Three-phase charger

Improved performance and increased power
MAXEON patented technology
Positive tolerance: 5%
Superior strength

The front side is completely black - The back side is white