Accessories

Wifi communication card to connect your SOLAX inverter and monitor its performance remotely.

Measure the current in your home with this sensor. It plugs directly into your Chint DDSU or DTSU meter.
Then connect this plug around the cable that runs between your home's electrical panel and your electricity supplier's meter.

These CT clamps can measure currents between 5A and 200A.

The diameter of these clamps is 24mm.

These clamps are programmed to work with SOLAX inverters and CHINT meters.

Add ENPHASE current transformers to monitor a polyphase or three-phase installation with the ENVOY-S Metered.

The SolarEdge 100 A current meter measures the current of your home and in the power grid. Connect to the SolarEdge electricity meter.

Order the AC cable for SOLAX X1 microinverter with a length of 2.2m. Generally used for installations with solar panels in horizontal format. It connects to the SOLAX trunk connector and allows the connection of all microinverters.

Battery cable for TRIPLE POWER H9.0 battery with a length of 1.8m

KNIPEX - Pince à sertir pour fiches Western RJ11 / RJ12 / RJ45, longueur 190mm

Battery cable for Growatt battery to install more than 3 APX 5.0-P1 modules

Electrical conduit for outdoor installation. You can run up to 8 wires inside. Be careful not to mix solar cables (direct current) and alternating current cables. Supplied with the wire puller to facilitate the installation of your cables indoors.

Connects directly to the solar inverter to monitor your home consumption and regulate the solar panels' power. Measures up to 100 A.

The connectors are located 2.4m apart from eachother. The quantity you select refers to the number of connectors. The connectors are already mounted on the cable. Of course this number is linked to the number of APS QT2 micro-inverters you have ordered.

This solution is ready to use.

For FRONIUS and SMA inverters.

Cable 1x4 mm² photovoltaic CR 100 m

Operation from -50 ° C to 150 ° C / Maximum voltage: 1,000 V

The ECU communication gateway is the core of your network. Owners can easily monitor the status of their system using the LCD screen or get information by solar panel via the monitoring software and APS testing.

ECU B only works for the communication of up to 4 solar panels.

With this card, the ABB inverter will automatically adapt the output power in order to maximise self-consumption or in order to avoid feeding power into the grid according to the system settings.

In addition, this UNO-DM-COM KIT is equipped with a configurable switching relay which can be used for manage external loads with custumizable activation power and temporal thresholds (basic load management capability).

The ABB inverter can be easily integrated with third party monitoring and control systems using this accessory board.

Plug & Play connection to inverter
Wifi communication via Smart Dongle-Wifi
Support of 3rd-party monitoring systems

Wifi communication card to connect your SOLAR-EDGE inverter via Wifi and monitor its performance remotely.

External Relay for IQ7 In Enphase installations, the Q Relay (Network System Relay Controller) acts as a physical disconnect relay controller for installations.

Measure the current in your home with this sensor that plugs around the chosen power cable. 

Connect up to 3 cables.

For SMA inverter Core1 set complet

Fixing for floor installation of GoodWe Lynx batteries. You only need one piece per location.

Cable 1x4 mm² photovoltaic CR 100 m

Operation from -50 ° C to 150 ° C / Maximum voltage: 1,000 V

Zigbee range extender dongle operating in 2.4GHz band for the Enphase IQ Battery To be used in specific conditions (not mandatory) specified in installation manual

Temperature sensor for SUNNY ISLAND. This sensor permit you to use a Lead battery.