Accessories

Wifi communication card to connect your SOLAX inverter and monitor its performance remotely.

Measure the current in your home with this sensor. It plugs directly into your Chint DDSU or DTSU meter.
Then connect this plug around the cable that runs between your home's electrical panel and your electricity supplier's meter.

These CT clamps can measure currents between 5A and 200A.

The diameter of these clamps is 24mm.

These clamps are programmed to work with SOLAX inverters and CHINT meters.

Add ENPHASE current transformers to monitor a polyphase or three-phase installation with the ENVOY-S Metered.

The SolarEdge 100 A current meter measures the current of your home and in the power grid. Connect to the SolarEdge electricity meter.

Order the AC cable for SOLAX X1 microinverter with a length of 2.2m. Generally used for installations with solar panels in horizontal format. It connects to the SOLAX trunk connector and allows the connection of all microinverters.

Battery cable for TRIPLE POWER H9.0 battery with a length of 1.8m

KNIPEX - Pince à sertir pour fiches Western RJ11 / RJ12 / RJ45, longueur 190mm

Battery cable for Growatt battery to install more than 3 APX 5.0-P1 modules

Electrical conduit for outdoor installation. You can run up to 8 wires inside. Be careful not to mix solar cables (direct current) and alternating current cables. Supplied with the wire puller to facilitate the installation of your cables indoors.

Connects directly to the solar inverter to monitor your home consumption and regulate the solar panels' power. Measures up to 100 A.

The connectors are located 2.4m apart from eachother. The quantity you select refers to the number of connectors. The connectors are already mounted on the cable. Of course this number is linked to the number of APS QT2 micro-inverters you have ordered.

This solution is ready to use.

For FRONIUS and SMA inverters.